| 1967 Chevelle Hot Red, LS2 Powered All Stainless lines used on this car were made here at HCC Performance. They were all cut to length, fittings installed, and then pressure tested. |
 The headlights, bumper, radiator and evaporator have been installed.  The LS2 being wired and plumbed.  The front of the fuel tank and stainless lines.  The rear end and brake line. Notice the line is run on the inside of the rear end so you will not see it from behind the car.  The fuel lines and regulator tucked into the frame. Also notice the brake line.  The fuel and brake line going into the frame. You can also see the power steering line running into the frame next to the "T" Junction for the brakes.  The fuel line running up to the engine  This shows the underside of the frame as a whole. There will only be a prop shaft and exhaust visible when we're finished.  The Transmission Cooler lines running into the frame.  The Trans Cooler lines coming out of the frame and running down the bottom of the radiator.  The Power Steering lines from underneath the car. NEXT PAGE |
